Sensorbility

Stairwells and Hallways

Our Bathroom Switch Controller is also ideal for switching lights in stairwells and hallways from multiple locations. The switch consists of a small controller housing that can be hidden in the ceiling cavity, either behind the light rose or adjacent to a relevant junction box, allied to satellite SensorPads.

Sensor Pads can be mounted behind faceplates of your own specification or design. These Sensor pads have no moving parts and are therefore less likely to be vandalised. The Multiway Controller can of course switch or control other electrical devices such as call bells etc.

ON/OFF Switch Controller
Use with Sensor Pads hidden behind almost any surface for simple ON/OFF touch switches.

Dimmer Switch Controller
Touch your chosen faceplate and the lights will turn on at low level, keep touching and the lights will begin to ramp up to full brightness, remove the hand and the lights will stay at the intensity reached. To switch off, touch briefly and the lights will slowly dim back down and switch off.

DIMMER/TIMER Switch Controller
In the timer version, the desired switch off delay is set within the controller and the lights will remain on and then switch off once the set time is reached.

Sensor Pads
The SensorPads themselves operate on only 5volts DC, and can utilize existing cabling. Only 2 wires per switch are used. The PCB of the SensorPad is no bigger than a postage stamp so the switching sites can be very un-obtrusive if necessary. This means that the cabling within the walls is only carrying this low voltage and therefore is very safe. Up to 6 SensorPads can be used to operate each controller and there is the provision to include an additional conventional switch or dimmer switch in the circuit.

Control stair & hall lights from multiple locations
No need for conventional 2-way switches
Numerous switch points, using Sensor Pads mounted behind almost any material.
Available as ON/OFF, DIMMER, or DIMMER/TIMER